How To Light A Gas Fireplace With A Key

Be sure to keep the key near the fireplace or in handy place with any of your other fireplace accessories so you don’t lose it. To turn on a gas fireplace with a wall key, grab a long lighter and place it near the burner.

Reasons Your Gas Fireplace Isnt Working – Fireplace Experts

You may hear a slight hissing as the gas enters the burner, and the pilot light should light immediately.

How To Light A Gas Fireplace With A Key

How to light a gas fireplace with a key. (you can also use a lit. Some older gas fireplaces have keys. When you are done using the gas fireplace, insert the key into the keyhole and turn it clockwise until it no longer turns to turn off the gas and extinguishe the flame.

Gas fireplaces provide warmth and a cozy atmosphere in almost any home. You’ll need a fireplace key to control the gas flow, including starting the fireplace. Most fireplaces, unless specified otherwise in the manual, have a gas control knob which is next to a colored button.

Turn the gas on at the lowest setting and press your pilot button down. If you have a fancy fireplace, you might see a round, decorative slot that’s used to control the gas valve. Gas fireplace with the pilot always on, has a hole with key in it on the floor right next to fireplace (based on prior answers thats for gas supply), a ‘light’ switch across the room that when flipped on basically turns the flames on and entire fireplace lights up, then a knob next to the light switch that when turned clockwise.

Place a long lighter next to the burner and pull the fuel trigger. If playback doesn't begin shortly, try restarting your device. Remove the outer cover of the fireplace to.

Replace the key cover, and use the key controls to adjust the height of the flame. Some gas fireplaces use a metal key to turn on the gas flow and start the flames. This works in a similar way than other ways to start the units.

That’s the simple way to light a gas. Pull the fuel trigger, and then use the wall key to open the gas. Then turn the fireplace’s handle parallel into the gas pipes’ direction so that you can turn the gas on.

To open the gas valve, turn the key. Lighting a gas fireplace using the control panel. Using a wall switch to turn on a gas fireplace;

Gas fireplace with the pilot always on, has a hole with key in it on the floor right next to fireplace (based on prior answers thats for gas supply), a ‘light’ switch across the room that when flipped on basically turns the flames on and entire fireplace lights up, then a knob next to the light switch that when turned clockwise. Press this button and you should see the pilot light turn on whenever you turn the gas control to start the gas. Turn the knob to the on position.

Set alight to the paper and place on the fireplace. Gas fireplaces provide warmth and a cozy atmosphere in almost any home. Lighting a gas fire with a key valve.

Amazon com midwest hearth gas fire pit key valve kit 3 4 npt. This will release gas into the fireplace, causing the pilot light to ignite. If you smell any gas, quickly open the window to air the room out, if there is a strong gas smell then exit the home and call the fire department.

Keep pushing the button until the pilot light turns on. Be prepared to move back quickly in case the fire ignites stray gas particles and flares out into the immediate surrounding area Go back to the knob for the pilot light ignition.

You will control the gas flow with a fireplace key (sometimes called a hex key) as you light the fireplace.

How To Light A Gas Fireplace