What To Do If Whirlpool Washer Won't Start

Reset the breaker and try to start the washer. Explore top load laundry set.

My Dishwasher Won't Dry Dishes! Appliance Repair Specialists

Whirlpool washer start button stuck.

What to do if whirlpool washer won't start. If the lid switch works but the washing machine still won’t start, check to see if your washing machine has a special fuse inside the control panel for it. To determine if the line fuse is at fault, use a multimeter to test it for continuity. The control lock feature may be enabled.

If your whirlpool washing machine won’t lock, turn on, unlock, or turn off, the lock may. Rotate the dial until rinse, wash, and stop light illuminate. Purchase an ohmmeter on amazon.

If there's no power running through the. If the switch is damaged or has failed electronically, it’s possible the whirlpool washer lid won’t unlock or signal a cycle to start. Next, check for a tripped circuit breaker.

Explore front load laundry set. If there no water flow on any selection go to step 2 below picture. If the line fuse blows, the washer won’t start.

Unplug the washing machine or turn off its power at the circuit breaker. The lid switch should automatically engage when the washer is on, and the lid is closed. If suspected flow problem is corrected, reconnect hoses and go back to step 1, otherwise, go to step 3 “test the whirlpool washer inlet valve” (skip step 2).

Remove and test the whirlpool washer water level switch (picture above) also known as a pressure switch. Is your whirlpool washer locked and won’t turn on? Subsequently, question is, is there a way to reset a whirlpool washer?

Resetting the machine can cycle its power, enabling it to start again. Press the start stop button once. The problem could be with the door interlock.

Once engaged, the switch locks the lid and signals the washer’s control panel to begin a wash cycle. Door interlock in a front load washer. In addition, you should investigate and resolve the problem that caused the fuse to blow.

If your whirlpool top load washer won’t unlock, a magnet can bypass the lock to open the lid. First, clean the area around the button with a damp paper towel and see if there’s any foreign material. In this way, why does my whirlpool washer not start?

If the lid switch works but the washing machine still won’t start, check to see if your washing machine has a special fuse inside the control panel for it. If the fuse is blown, replace it and try the washer to see if it works. After one minute, restore power and try starting the washer.

There are a few things you can do to fix your whirlpool washer whenever the start button doesn’t work. Control lock is turned on. Check the continuity with a multimeter.

Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset. If the fuse does not have continuity, replace it.

If neither is at fault, you may have a damaged power cord. Make sure the machine is tightly plugged in.

6 Whirlpool Washer Troubleshooting and Repair