Automate Remote Start Not Working

It would have to be diagnosed with a dvm. Automate just calls it the am6.2.

Viper 5704Z Remote Start System Crutchfield Video

Using the system (remote start/unlock function) start engine when the engine is off, press and release the remote control button to start the engine.

Automate remote start not working. Automate car security remote starter toyoata 2012 rav 4. Here is a link to the avital 4113 install guide : I have 2011 ford taurus sel with automate am 6.2 r.

Turn off the ignition and remove the key, the engine continues running. Automate remote start not working. Automate car security remote starter 476a.

Exit and secure the vehicle, the engine runs for the programmed runtime. I bet you it’s not the remote start system. Instruction manual for programming 476a automate s.

Of times the system has been programmed to activate the remote start). As for the remote start not working, sounds like a wiring problem. Automate remote start not working.

Could be a bad solenoid on the starter(if that applies), it could be rotted ground wire that runs from the engine block to the frame. The ignition circuit appears to be energized,(dash lights come on) the lights come on, then everything shuts off. Dash lights are on so it's not a hood switch or cut off switch problem iether.

Automate just calls it the am6.2. I bet you it’s not the remote start system. Automate car security remote starter am 6.2.

The parking lights turn on to confirm. If so, it could be interfaced to turn off with the am6. #1 take it to the remote start shop and ask them to verify it’s def not the remote start.

This feature will not work if the brake pedal is being pressed. There is no immobilizer on that car so that's not the issue. Refer to the following table for the likely cause.

If the remote start fails to turn on, the vehicle parking lights will flash to indicate the cause.