How To Open Honeywell Thermostat To Change Battery

If your thermostat was low on battery and you’ve replaced them but it still won’t work, do the following: Some thermostats need to be taken down from the wall in order to replace the battery.

Honeywell Th4110u2005 – T4 Pro Programmable Thermostat 1 Heat 1 Cool In 2021 Programmable Thermostat Honeywell Digital Thermostat

Set the thermostat to an off position;

How to open honeywell thermostat to change battery. It will either swing up or down, or side to side. Grip the face plate of the thermostat and pull it away from the wall plate to expose the batteries. If batteries are inserted within two minutes, the day and time will not have to be reset.

If the thermostat is not working properly or indicates a low battery, then it’s time for a battery change. Press the blank button in the middle and hold it. Be sure to reprogram your thermostat to your normal schedule.

Removing the thermostat from the wall is not required. Now that the battery compartment has the new batteries, slide the compartment back into the thermostat. How to factory reset the honeywell 8320wf thermostat.

Wait ten seconds and put them back in the correct way. The five buttons at the bottom will come up blank. Generally, you can change the batteries of the honeywell thermostat by just pulling out the cover plate or just sliding out the battery compartment.

It only requires knowing how to locate the batteries and access them. Put the batteries in the wrong way, with negative to positive and positive to negative. Replace the battery and put it as it was earlier.

How to open honeywell thermostat to replace battery. Press system on the left side of the screen. Open the battery compartment and remove the batteries

Push the battery door open by inserting a coin (or a similar alternative) into the slot found on the door. Follow these steps to change the honeywell thermostat battery: The following steps are helpful to change the battery in honeywell thermostats.

If your honeywell thermostat has a swinging cover, there will be an edge that sticks up around the side of the thermostat. Honeywell thermostat won’t work after replacing batteries. Carefully extract the batteries, and replace them.

Find that location, and use your fingers to grasp the edge of the cover and gently swing it open. The battery housing is not labeled but it is easy to locate it. Power off the thermostat and remove the batteries.

Your thermostat will be reset to factory settings. Locate the batteries by removing the battery compartment tray or cover or by removing the unit’s faceplate. All honeywell thermostats that have batteries store the batteries in the control panel.

The thermostat comes with a sliding battery compartment and you do not have to open the cover from the base plate to replace the battery.

How-tohow To Change Battery In Honeywell Thermostat Different Models – Howtoorg