If some of the buttons respond correctly but others don’t, it is likely that the touchpad is at fault. Kenmore elite dishwasher (665.13752k602) will fill and heat the water.
Either way, you can find the possible causes below.
Kenmore dishwasher won't start cycle. None of the buttons seem to have any effect, either to change to a different wash cycle or to start it in the china cycle. Kenmore dishwasher start light blinking the start light will usually blink if the dishwasher cycle has been interrupted, and you need to press the start button to resume or restart the cycle. The clean led indicates the water is low or too cold, the latch is broken, or a circuit error has occurred.
Make sure cycle indicator dial is turned far enough and cycle button is fully pushed in. When your kenmore elite dishwasher won’t start, there are a few likely causes. There are a number of reasons why your dishwasher won’t turn on.
If the kenmore dishwasher won’t start, it’s possible you have incorrectly set a cycle. My kenmore dw had similar issues. Kenmore dishwasher won't start cycle.
Then it sounds like the pump tries to start the cycle, but it just buzzes. Kenmore dishwasher fills but won't wash/cycle. Kenmore dishwasher won't start cycle.
This could mean there are no lights displayed and the dishwasher is completely unresponsive, or that the lights are on but it won’t start the cycle. This is the most common reason that any dishwasher, not just kenmore elite models, won’t start. The main control board provides power to nearly every component of the dishwasher.
If the display is still working, try pressing some of the touchpad buttons. Check house fuse or circuit breaker. Clean light blinks seven times and dishwasher won’t start.
Dial not in correct position for cycle selected. Then i followed the instructions given here to fix the blinking clean light. The first two times that i pulled it out to check connections, it started after pushing it back in place, but now nothing.
It then proceeds to go through the whole cycle, but after realizing it wasn't doing anything i shut it. It will operate for a couple of minutes then it will stop and turn on and off repeatedly. To determine if the thermal fuse is defective, use a multimeter to test the fuse for continuity.
If there is a problem with the main control board, it might not send voltage to the dishwasher, causing the dishwasher not to start. The lights on a kenmore dishwasher flash to indicate an error. The start led indicates power was lost or the door was opened during a cycle.
Clean light blinks seven times and dishwasher won’t start. No water supply water inlet valve clogged. If one of these indicators is lit up, but the machine isn’t doing anything, that could be why it’s not starting correctly.
The indicator lights on your dishwasher show which cycles are running and when they’re finished. This issue is likely the result of a faulty timer, water line valve, or lid switch. Kenmore dishwasher won’t turn on.
When the door can’t close, the cycle can’t begin. When the switch isn’t latched or has become defective, the door won’t close. The dishwasher will not start.
I ordered the heating element from repair clinic and installed it. When i close & latch the door, the china gentle light goes on and remains lit (solid, not flashing). I have a kenmore elite dishwasher which just started not complete any cycle besides the drain cycle.
Kenmore dishwasher won't start cycle. Dishwasher will not fill with water. I have am kenmore ultra wash dishwasher model number 665.16872.
Kenmore dishwasher fills but won't wash/cycle. Kenmore elite clean light is blinking & wash cycle won’t start. This is the most common reason that any dishwasher, not just kenmore elite models, won’t start.
First, confirm that the dishwasher display is working.